Site Information

 Loading... Please wait...
  • Image 1
  • Image 2

Switchfet V2.5

$9.00
Current Stock:
8
Quantity:

Product Description

The Switchfet v2.5 is an all in one solution to providing mosfet switched capability for bottom feeding personal vaporizers that use lithium-ion cells, without compromising space owing to its small footprint, allowing you to build clutter free internals.
Power consumption is practically zero when not switched.
The board incorporates a voltage supervisory circuit which monitors the input voltage
Which enables under voltage lockout when the input voltage falls below 2.7 volts.

We have packs of 0 ohm resistors should you wish to use the wiring diagram below.


ASSEMBLY
The assembly is very simple using three wires of adequate thickness for single cell operation
Negative input & Negative 510 output has been designed for 18 AWG, the positive input will accept 24 AWG though smaller gauge is acceptable.

OPERATION
Operation is very simple by pressing the onboard switch.

RECOMMENDATIONS
The board has Reverse polarity protection onboard and will autofire when cell is installed in reverse.

LIMITATIONS
Although there is a 100A mosfet fitted, due to board limitations of size there is an amperage limit of 50 Amps.

SPECIFICATIONS
Footprint:-   13mm x 13mm x 4.2mm
Mosfet:- 30v 100A LFPAK, RDSon 1.35m Ω (typ), VGS(th) 1.46v (typ)
Operational voltage:-   2.7v - 4.20v
Battery cut-off :- 2.7v
Idle current :-   typical 1.3μA max 3.3μA
Reverse polarity protection :- Yes
Board amperage Limit :- 50A

Product Reviews

Write Review

  1. great with 1 niggly point 4 Star Review

    Posted by on Dec 11th 2017

    Great piece of kit this, cuts WAY down on space useage compared to the typical mosfet+pushbutton setup. Just wish it was easier to mount..

Find Similar Products by Category

Click the button below to add the Switchfet V2.5 to your wish list.